Drag Strip Handling. Are you part of the drag racing crowd that is looking for great weight transfer and the ultimate in straight-line acceleration? Then you need to install a set of BMR Drag Lowering Springs on your S550 GT Mustang. These BMR Lowering Springs feature a linear spring rate that provide maximum traction to the drive wheels. The results are lower 1/4-mile Elapsed Times (ET´s) down the strip.

Sleek Muscle Car Stance. Not only does a set of BMR Springs improve the handling performance of your Mustang, but they also improve its overall appearance. By lowering the ride height approximately 1.2″ up front and 0.5″ in the rear these BMR Performance springs will eliminate that huge tire to fender gap, for a sleek muscle car stance.

Superior Construction. Designed and manufactured in the USA, these BMR Lowering Springs are CNC cold wound from chrome silicon high-tensile spring wire. To guarantee that their springs will not sag over time, BMR fully compresses every spring twice to permanently set the spring. To eliminate the stresses induced during the winding process BMR springs are stress-relieved at 750 degrees F. Shot-peening is then used to eliminate any residual surface stresses. As the final step every spring is compressed and tested allowing BMR to offer a Lifetime Warranty against spring sag.

Clears Stock and Aftermarket Wheels & Tires. These lowering springs were engineered to be compatible with your factory size wheels and tires, as well as many other aftermarket wheel and tire combinations

Choice of Options. BMR Drag Lowering Springs are available as a pair of two Front Springs, a pair of Two Rear Springs or as a complete set of four. Please select from the options listed above.Application. These BMR Drag Lowering Springs are specifically designed for use on 2015 to 2020 GT, EcoBoost and V6 Mustangs.

Technical Note. The Springs are not compatible on vehicles equipped with the MagneRide Suspension.